TO: Multi-Tech Products

What would cause this wrinkling during a repair?   (see photo below)

image1

 

 

 

 

 

 

Thanks,
Ryan

To: Ryan

I could give a more specific answer if you had provided more information. Were you using our MMA system, or the Quick Glaze process? What filler was used? What steps did you take prior to seeing the wrinkling? Did you follow our procedures?

So, I will try to explain all of the potential causes. If you were using the Quick Glaze system, it could occur during the spraying operation.

The Base Coat is first sprayed on the surface, and it contains a hardener that cures the coating. The Clear Coat needs to be applied before the Base Coat is completely cured. Otherwise, the solvents in the Clear Coat will attack the Base Coat, and it can create the wrinkling. The Clear Coat can go on directly over the color. The Finishing solvent can also be sprayed directly on to these coatings.. All of the coatings should be applied consecutively, as quickly as possible. Under normal ambient temperatures, the time window is about 45 minutes. Higher temperatures will reduce this working time. Waiting 45 minutes or longer to apply the Clear Coat will make the Color coatings wrinkle. The retarder must also be used as the reducer for the base color coat for thinning. Against all of our recommendations, some people fail to use the QG Clear Coat. If there is no clear coat on the application, you will need to remove the color by sanding and applying a lacquer thinner to remove all of the coatings before re-applying them, correctly..

These issues do not exist with the MMA system. Furthermore, the operating time windows on applying the various MMA coatings are very flexible

However, the MMA System or the Quick Glaze system can lift or wrinkle a previously sprayed repair. For example, it can occur when an epoxy or other unknown coating was used as the base color spray. However, both systems can work well as a touch up of a complete refinish job unless the refinish coating that was used was an epoxy, or there was no clear coat used..

A less common cause is something wrinkled under the color and the clear coats. It could have been the filler, or you sprayed over uncured resin in the FRP shell? If it is uncured resin with this level of wrinkling, the area would be soft when poked with a screw driver or sharp tool.

Hope this helps.

Rob

 

Advertisements