Tag Archive: FRL


To:  Multi-Tech Products

I want to thank you for your assistance in supplying a great system and help to replace and renew part of the surface of a swim spa installed in a home in Alaska.  The spa was originally produced from a co-extruded polymeric sheet with fiberglass reinforced resin for mechanical support.  Due to the presence of un-cured resin in the support structure, blisters had occurred around the bottom of the spa.  They were too numerous and widespread to repair with your standard procedure.  Furthermore, as the picture below shows, it would have been very expensive to remove and replace the entire spa   You can also see a photo showing some of the blisters..

IMG_3336.IMG950658

These blisters were located only around the lower portion of the spa, so your procedure for renewing a portion of a spa surface was ideal for this job.  As your procedures state, we created a line of demarcation establishing the boundary of the material to be removed and replaced.  Then we stripped this top layer from the spa with  the aid of a chisel and hammer.  We removed the entire bottom  of the spa.   Then we applied new fiberglass mat and resin using your FRL Kit to the affected surface.   See photos.

IMG_0684 IMG_0681IMG_0697

Padres Spa Pictures 223

 

We completed the job following your recommendations using the products in your kit.  The following photo shows the final result.  The home owner was ecstatic about the appearance, and our ability to repair it without the demolition of replacing the entire spa.

IMG_2098

Thanks again,

Jeff

To:  Jeff

I want to thank you for your testimonial on our FRL (Fiberglass Reinforced Lining) System.  It was designed especially for this application, and we have had many satisfied customers including the San Diego Padres baseball team where the spa in their locker room was renewed.  We also want to thank you for trusting and using all of our products to repair spas and bathtubs made from acrylics, gelcoat, and other materials.

Regards,

Rob Clos

President

Advertisements

MY SPA SURFACE HAS LOTS OF DEFECTS/DAMAGE.  CAN IT BE REPAIRED?

After years of service and use, the original surface of a spa may become faded, damaged, cracked, blistered, or defective in some way.  Mechanically, the spa is still  very functional, and it is leak-free, but the appearance of the surface is objectionable.  In these cases, the owner may prefer refurbishing the entire surface rather than purchasing a new replacement spa.  This should be performed by a professional, trained surface repair contractor.

Materials and procedures have been developed by Multi-Tech Products Corporation to renew the surface of spas with a white layer of reinforced resin.  The fiberglass reinforced lining system (FRL) includes a white polyester resin and fiberglass matting for reinforcement.  If applied properly, the products will extend the useful life of a spa for several years.  The materials and techniques provide an attractive, solid white textured surface.

Please call MTP for more information, and to order materials.

.